Futaba 14SGH 14-Ch Helicopter Transmitter w/ R7008SB RX & Telemetry

SKU : Futaba 14SGH w/ R7008SB RX

Availability : Out of stock

Price : Regular price $699.99

Description
Reviews

All the functions flyers demand in one comfortable radio!

Futaba proudly introduces the 14SG, the only 14-channel system with revolutionary 2.4GHz FASSTes!t technology. It's also compatible with Futaba FASST and S-FHSS protocols, so you can use virtually all Futaba 2.4GHz air receivers. The 14SG can also transmit and receive telemetry data. Install Futaba telemetry sensors (sold separately) to monitor flight data, receive alerts while in flight and more. Heli pilots will prefer the 14SG's flybarless gyro support - which makes the 14SG the perfect system for flybarless flight. That's just the beginning! To see everything that the 14SG can do, read on...

Channels: 12 proportional, 2 switched
Compatible with FASSTest, FASST and S-FHSS protocols
FASSTest telemetry compatible with Futaba telemetry sensors (sold separately)
Free user-updatable software
30-model memory
10-character user naming
10-character model naming
Airplane, helicopter and glider programming
Large, 1.75 x 3 backlit LCD screen with 128 x 64 resolution
SensorTouch programming
Compatible with secure digital memory cards for external storage of model setups and software updates (32MB-2GB or HC (High-Capacity) 4GB-32GB)
Left and right assignable slider switches
Two assignable rotary knobs
Six assignable three-position switches
One assignable momentary two-position switch
One assignable two-position switch
Comfortable rubber grips on the sides and back

Wide top switch spacing
Adjustable stick tension
Dual ball bearing gimbals
4 vibration warning types
Home/Exit; User Menu/Servo Monitor buttons
Audio earphone jack (for telemetry alarms)
6V 1800mAh NiMH battery pack
User stick calibration
Trainer system
Servo speed adjust
5 programmable mixes
V-tail, Ailvator, winglet, motor mixing
Trim mix
Logic switch (condition switch only)
Internal programmer for S.Bus servos
User menu
Servo monitor (neutral and moving tests)
2 count up/countdown timers
Integral timer
Model timer
Quick model select

Helicopter Programming Features

6 swash plate types
Pitch/throttle curves (5-point)
Throttle hold
Swash mix
Throttle mix
Pitch to rudder mixing
Fuel mixture
Gyro (Flybarless support)

Governor (700-3500 rpm)
Hover pitch
Hover throttle
High/low pitch
Swash AFR
Swash setting (mixing rate, linkage compensation, speed compensation)
Swash ring (electronic)
Throttle cut

Notes from our tech department:

This is the Futaba 14SGH 14 Channel 2.4GHz Computer Radio System on mode
with the R7008SB Receiver
**Does Not Include Servos**

This is the mode version-the left stick controls
throttle and rudder and the right stick controls elevator and ailerons

This is the helicopter version which will default to heli settings
when powered up.

FEATURES

2.4GHz FASSTest technology is also compatible with Futaba FASST and
S-FHSS protocols, allowing this system to be used with most 2.4GHz
air receiver Futaba produces
Transmits and receives telemetry data with Futaba telemetry sensors
(not included, sold separately)to monitor flight data, receive
alerts and more. See COMMENTS below
30 model memory with 10 character model naming and 10 character user
naming
Left and right assignable slider switches
Two assignable rotary knobs
Six assignable three-position switches
One assignable momentary two-position switch
One assignable two-position switch
S.BUS2 programmability allows multiple servos, gyros and telemetry
to be installed with minimum amount of cables
Programming port and earphone jack
Model data can be saved to an SD card (not included, purchase
separately SD:32MG-2GB, SDHC:4GB-32GB)
One year limited warranty through the Futaba USA Service Center
beginning at date of purchase
Airplane Features;
7 different wing types, 3 different tail types, 2 different rudder
types
Flap setting menu
Differential ailerons
Aileron to camber flap mixing, aileron to rudder mixing
Rudder to aileron mixing and rudder to elevator mixing
Camber mixing, elevator to camber mixing, camber flap to elevator
mixing
Snap roll, V-tail and airbrake mixing
Ailevator
Winglet
Motor mixing
Fuel mixture mixing (single and twin)
Gyro mixing
Throttle curve (5-point), Pitch curve (5-point)
Idle down
Helicopter Features;
6 swash plate types
Pitch/throttle curves (5-point)
Throttle hold
Swash mix
Throttle mix
Pitch to rudder mixing
Fuel mixture
Gyro (flybarless support)
Governor (700-3500 rpm)
Hover pitch and throttle
High/low pitch
Swash AFR
Swash setting (mixing rate, linkage and speed compensation), swash
ring (electronic)
Throttle cut

Glider Features:
11 different wing types, 3 different tail types, 2 different rudder
types
Flap setting menu
Differential Ailerons
Aileron to camber flap mixing
Aileron to brake flap mixing
Aileron to rudder and rudder to aileron mixing
Rudder to elevator mixing
Camber mixing
Elevator to camber mixing
Camber flap to elevator mixing
Butterfly mixing, butterfly to elevator mixing

INCLUDES

Futaba 14SGH 14 Channel 2.4GHz Computer Radio System on mode 2 with
R7008SB Receiver, 6V 1800mAh NiMH Transmitter Battery, Instruction
Manual, and LiFe Spacer for optional FT2F2100B/FT2F1700B battery*
pack, Battery Charger, Neck Strap, and Switch Harness

REQUIREMENTS

Servos of modeler's choice

SPECIFICATIONS

Transmitter;
Transmitting Frequency: 2.4GHz band
System: FASSTest14CH, FASSTest12CH, FASST MULTI, FASST 7CH, S-FHSS
switchable
Power Supply: 6.0V HT5F1800B NiMH battery

R7008SB Receiver (FUTL7675);
Receiving Frequency: 2.4GHz FASSTest system
Power Requirement: 3.7 - 7.4V (voltage range 3.5 - 8.4V)
Current drain: 75mA
Extra Voltage Port: 0 - 70V DC
Size: 0.98 x 1.9 x 0.56" (24.9 x 47.3 x 14.3mm)
Weight: 34.5oz (980g)